Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Salt Lake City, UT

Ideal Door Torsion Spring Replacement in Salt Lake City, UT

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

When your door needs Ideal Door torsion spring replacement, you want it done safely and right the first time. Typical jobs in Salt Lake City, UT cost $200-$450, and you approve the price first. Torsion springs replaced and wound correctly, with high-cycle upgrades available. We work on Ideal Door garage doors of every age, from older models to current lines, and carry or can source compatible parts.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for Ideal Door torsion spring replacement

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

What usually causes it

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

Safe checks before you call

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Ideal Door torsion spring replacement

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Ideal Door Torsion Spring Replacement cost in Salt Lake City, UT

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Ideal Door services

Ideal Door Torsion Spring Replacement in Salt Lake City, UT

In Utah, cold mornings after mild afternoons put the most stress on worn springs, so breaks are common in late fall and winter.

Our Ideal Door torsion spring replacement service covers Salt Lake City (ZIP codes 84101, 84102, 84103, 84104, 84105 and more) and nearby towns including South Salt Lake (2.9 mi), Millcreek (5.2 mi), Canyon Rim (5.2 mi) and East Millcreek (6 mi). Call (833) 435-8883 to book a visit in Salt Lake City.

Ideal Door Torsion Spring Replacement: frequently asked questions

How much does Ideal Door torsion spring replacement cost in Salt Lake City, UT?

Ideal Door Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Ideal Door torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Ideal Door torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Ideal Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Utah or Salt Lake City requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Salt Lake City, UT

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Overhead Door Garage Door Installation

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $1,200-$4,500

Smart Garage Door Opener Setup

Wi-Fi openers and smart hubs set up so you can open, close and monitor from your phone.

Typical $100-$900

Hörmann Smart Garage Door Opener Setup

Wi-Fi openers and smart hubs set up so you can open, close and monitor from your phone.

Typical $100-$900

Amarr Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Moore-O-Matic Remote & Keypad Programming

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $50-$150

Sommer Garage Door Opener Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$350

Haas Door Extension Spring Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$350

Hörmann Garage Door Cable Repair

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

Clopay Garage Door Roller Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Salt Lake City, UT now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote